Skip to content

Revo 2

High Performance 5-axis Measurement System

A REVO® system delivers high performance scanning, non-contact inspection and surface finish analysis on a single CMM.

The REVO® system uses synchronized motion and 5-axis measurement technology to minimize the dynamic effects of CMM motion at ultra-high measurement speeds.
This is achieved by letting the REVO-2 head do the fast demanding motion while the CMM moves in a linear slow fashion. The use of a flexible tip-sensing probe system further adds to the system’s accuracy and flexibility. The removable probe system, used in conjunction with a low cost changer, provides added system flexibility.

Multi-sensor 5-axis measurement system

Revo 2 Multi-sensor 5-axis measurement system

Faster calibration

Calibration on traditional CMM systems consumes a considerable amount of time that could otherwise be used for part measurement.

Using a table mounted sphere, the simple and practical calibration technique for REVO-2 determines the actual head and probe geometry, allowing measurement in any position from a single operation.
If the CMM is used for multiple parts, typically there may be 40 head orientations, dramatically increasing the time required for calibration to around two hours. Again, REVO-2 requires only 20 minutes.
As the calibration process is repeated on a regular basis, to comply with quality procedures or following a probe crash, these time savings accumulate.

Renishaw Revo2 gives users of all brands of CMM access to state-of-the-art technology.

Revo2 provides greater accuracy, faster measurement, more automation, and new capabilities, while taking full advantage of CAD-driven programming

REVO2 multi-sensor system

RSP2

RSP2 is a dedicated lightweight tip-sensing probe for use on REVO systems, capable of 2D-scanning (x, y) and 3D-touch trigger measurement.

SFP 2 CMM measurement

SFP 2

Makes surface finish inspection an integral part of the CMM measurement procedure, automatically switching between scanning and surface finish capability.

RSP3 3D-scanning xyz and crank stylus capabilities

RSP3

The RSP3 range complements the RSP2 probe, providing the REVO system with 3D-scanning (x,y,z) and crank stylus capabilities. It is used for 3-axis scanning, such as with a fixed REVO head angle during measurement.

RSP3-6 3D-scanning xyz and crank stylus capabilities

RSP3-6

The RSP3-6 provides enhanced capability for accessing deep bores and inspecting features within large parts. It is available with a range of stylus holders for applications requiring straight and cranked extensions and can be used for both touch-trigger and 2D scanning applications.

REVO-2 RVP probe non-contact inspection

RVP

The REVO-2 RVP probe adds non-contact inspection to the existing touch-trigger, high-speed tactile scanning and surface finish measurement capability of the REVO system allowing full inspection of parts and features unsuitable for tactile measurement.

RFP1 probe non-contact structured light inspection

RFP1

The RFP1 probe adds non-contact structured light inspection capability to the REVO multi-sensor system. RFP1 provides high-density data at a high capture rate, perfect for inspection of freeform surfaces and complex geometry.

RUP1 ultrasonic probe single-sided measurement

RUP1

The RUP1 ultrasonic probe enables single-sided measurement of part thicknesses, enhancing the capability to measure features previously not accessible by tactile systems.

RTP1 probe automated part temperature measurement

RTP1

The RTP1 probe adds automated part temperature measurement to the REVO 5-axis system capabilities.